pKmcqsquiz

Pagination on API result
Question: In a common emitter, unbypassed resister provides___________?
  • 1. voltage shunt feedback
  • 2. current series feedback
  • 3. negative voltage feedback
  • 4. positive current feedback
Question: . If =0.98 ,Ico=6µA and Iβ=100µA for a transistor,then the value of Ic will be______?
  • 1. 2.3mA
  • 2. 3.2mA
  • 3. 4.6 mA
  • 4. 5.2mA
Question: The MOSFET switch in its on-state may be considered equivalent to_____________?
  • 1. resistor
  • 2. inductor
  • 3. capacitor
  • 4. battery
Question: An npn BJT has gm=38mA/v, cµ =10¯14 F, cπ =10¯13F and DC current gain β0=90.For this transistor fT & fβ are________?
  • 1. fT =1.64 x 108 Hz & fβ = 1.47 x 1010 Hz.
  • 2. fT =1.47 x 1010 Hz & fβ = 1.64 x 108 Hz
  • 3. fT =1.33 x 1012 Hz & fβ = 1.47 x 1010 Hz
  • 4. fT =1.47 x 1010 Hz & fβ = 1.33 x 1012 Hz
Question: An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed____
  • 1. 795mV
  • 2. 395mV
  • 3. 795 mV
  • 4. 39.5mV
Question: Three identical amplifiers with each one having a voltage gain of 50,input resistance of 1KΩ & output resistance of 250 ,are cascaded.The open circuit voltage gain of combined amplifier is_________?
  • 1. 49dB
  • 2. 51dB
  • 3. 98dB
  • 4. 102dB
Question: The cascade amplifier is a multistage configuration of__________?
  • 1. CC-CB .
  • 2. CE-CB
  • 3. CB-CC
  • 4. CE-CC
Question: The encapsulation of transistor is necessary for__________?
  • 1. preventing radio interference
  • 2. preventing photo-emission effects
  • 3. avoiding loss of free electrons
  • 4. mechanical ruggedness
Question: In all base driver amplifiers__________?
  • 1. ac collector voltage is 180° out of phase with ac base voltage
  • 2. ac emitter voltage is 180° out of phase with ac base voltage
  • 3. ac collector voltage is in phase with ac base voltage
  • 4. none of the above
Question: The parameter hie stands for input impedance in _____________?
  • 1. CB arrangement with output shorted
  • 2. CC arrangement with output shorted
  • 3. CE arrangement with output shorted
  • 4. None of the above

Search

Category

Subjects