Question: For 100 sq. m cement concrete (1 : 2: 4) 4 cm thick floor, the quantity of cement required, is_______________?

• 1. 0.90 m3
• 2. 0.94 m3
• 3. 0.98 m3
• 4. 1.00 m3

Question: For 12 mm thick cement plastering 1 : 6 on 100 sq.m new brick work, the quantity of cement required, is___________________?

• 1. 0.200 m3
• 2. 0.247 m3
• 3. 0.274 m3
• 4. 0.295 m3

Question: The height of the sink of wash basin above floor level is kept____________________?

• 1. 60 cm
• 2. 70 cm
• 3. 75 cm to 80 cm
• 4. 80 cm

Question: The expected out turn of brick work in cement mortar in foundation and plinth per mason per day, is ________________?

• 1. 1.00 m3
• 2. 1.25 m3
• 3. 1.50 m3
• 4. 1.75 m3

Question: Pick up the item whose weight is added to the weight of respective item, is________________?

• 1. Cleats
• 2. Brackets
• 3. Bolts
• 4. All the above

Question: The ground surface slopes 1 in 50 along a proposed railway embankment 150 m in length. The height of the embankment at zero chainage is 0.5 m, the width is 11 m and side slopes 2:1. If the falling gradient of the embankment is 1 in 150, the quantity of t

• 1. 3250 m3
• 2. 3225 m3
• 3. 3275 m3
• 4. 3300 m3

Question: S: 1 and length is______________?

• 1. d × d × s
• 2. d2 × ( ds)2
• 3. L.D 1 + s2)
• 4. 2 L.D 1 + s 2)

Question: Pick up the correct statement from the following?

• 1. All pipes and fittings are classified according to their diameters
• 2. The diameter of the pipes is the nominal diameter of internal bore
• 3. All pipes are measured along the centre line of the pipes in metres
• 4. All the above

Question: Pick up the correct statement from the following?

• 1. In a gully trap, a water seal of 6 to 7.5 cm is provided
• 2. The gully trap collects waste water from the kitchen, sink, wash basins, etc.
• 3. The gully trap disconnects the sullage drain from the main drainage system
• 4. The grating provided over gully traps is 23 cm square

Question: Pick up the correct statement from the following?

• 1. The bent up bars at a support resist the negative bending moment
• 2. The bent up bars at a support resist the sharing force
• 3. The bending of bars near supports is generally at 45°
• 4. All the above