pKmcqsquiz

Civil Engineering Mcqs

Pagination on API result
Question: The suitable surfacing material for a bridge deck slab is________________?
  • 1. sheet asphalt
  • 2. bituminous carpet
  • 3. mastic asphalt
  • 4. rolled asphalt
Question: The thickness of bituminous carpet varies from__________________?
  • 1. 20 to 25 mm
  • 2. 50 to 75 mm
  • 3. 75 to 100 mm
  • 4. 100 to 120 mm
Question: Select the correct statement________________?
  • 1. Quantity of binder required for tack coat is less than that required for prime coat
  • 2. Prime coat treatment is given for plugging the voids in water bound macadam during bituminous road construction
  • 3. Seal coat is the final coat over certain previous bituminous pavements
  • 4. A bitumen primer is a high viscosity cutback
Question: Which of the following is considered to be the highest quality construction in the group of black top pavements ?
  • 1. mastic asphalt
  • 2. sheet asphalt
  • 3. bituminous carpet
  • 4. bituminous concrete
Question: Which of the following represents a carpet of sand-bitumen mix without coarse aggregates ?
  • 1. mastic asphalt
  • 2. sheet asphalt
  • 3. bituminous carpet
  • 4. bituminous concrete
Question: The drain which is provided parallel to roadway to intercept and divert the water from hill slopes is known as_______________?
  • 1. sloping drain
  • 2. catchwater drain
  • 3. side drain
  • 4. cross drain
Question: In hill roads the side drains arc provided________________?
  • 1. only on the hill side of road
  • 2. only on the opposite side of hill
  • 3. on both sides of road
  • 4. none of the above
Question: The minimum design speed for hairpin bends in hill roads is taken as_______________?
  • 1. 20 kmph
  • 2. 30 kmph
  • 3. 40 kmph
  • 4. 50 kmph
Question: In highway construction on super elevated curves, the rolling shall proceed from_________________?
  • 1. sides towards the centre
  • 2. centre towards the sides
  • 3. lower edge towards the upper edge
  • 4. upper edge towards the lower edge
Question: The camber for hill roads in case of bituminous surfacing is adopted as________________?
  • 1. 2%
  • 2. 2.5%
  • 3. 3%
  • 4. 4%

Search

Category

Subjects