Electrical Engineering Mcqs
Question: When the graph between current through and voltage across a device is a straight line, the device is referred to as _______________?
- 1. linear
- 2. active
- 3. nonlinear
- 4. passive
Question: The PIV rating of a crystal diode is _______________ that of equivalent vacuum diode.
- 1. the same as
- 2. lower than
- 3. more than
- 4. none of the above
Question: The leakage current in a crystal diode is due to _________________?
- 1. minority carriers
- 2. majority carriers
- 3. junction capacitance
- 4. none of the above
Question: The reverse current in a diode is of the order of _____________?
- 1. kA
- 2. mA
- 3. μA
- 4. A
Question: In deriving ac equivalent circuit for an amplifier circuit, we short circuit___________?
- 1. all resistors
- 2. all transistors
- 3. all inductors
- 4. all capacitors
Question: In an op-amp differentiator:________________?
- 1. the amplitude of output is proportional to rate of change of input
- 2. the amplitude of output is proportional to input
- 3. output occurs when input is finite and constant
- 4. polarity of input and output is the same
Question: The early effect in a bipolar junction transistor is caused by_______________?
- 1. fast turn-on
- 2. fast turn-off
- 3. large collector-base reverse bias
- 4. large emitter-base forward bias
Question: A source follower using an FET usually has a voltage gain which is___________?
- 1. greater than +100
- 2. slightly less than unity but positive
- 3. exactly unity but negative
- 4. about -10
Question: An OPAMP has a slew rate of 5 V/μ S .The largest sine wave O/P voltage possible at a frequency of 1 MHZ is [Hint: Slew rate is defined as the max. rate of change of output voltage. Its unit is V/μS.
- 1. 10 volts
- 2. 5 volts
- 3. 5/1 volts
- 4. 5/2 volts
Question: A differential amplifier is invariably used in the i/p stage of all OP-amps. This is done basically to provide the OP-amps with a very high_________?
- 1. CMMR
- 2. Bandwidth
- 3. Slew rate
- 4. Open-loop gain