Electrical Engineering Mcqs
Question: In a CB amplifier the maximum efficiency could be____________?
- 1. 99%
- 2. 85%
- 3. 50%
- 4. 25%
Question: The horizontal intercept of dc load line is the same as ideal____________?
- 1. cut off point
- 2. saturation point
- 3. operating point
- 4. quasi saturation point
Question: Which of the following amplifier circuit using junction transistor has the best gain?
- 1. Common base
- 2. Common emitter
- 3. Common collector
- 4. All have the same gain
Question: MOSFET can be used as a__________?
- 1. current controlled capacitor
- 2. voltage controlled capacitor
- 3. current controlled inductor
- 4. voltage controlled inductors
Question: A differential amplifier has a differential gain of 20,000 . CMRR=80 dB. The common mode gain is given by________?
- 1. 2
- 2. 1
- 3. 1/2
- 4. 0
Question: In a common emitter, unbypassed resister provides___________?
- 1. voltage shunt feedback
- 2. current series feedback
- 3. negative voltage feedback
- 4. positive current feedback
Question: . If =0.98 ,Ico=6µA and Iβ=100µA for a transistor,then the value of Ic will be______?
- 1. 2.3mA
- 2. 3.2mA
- 3. 4.6 mA
- 4. 5.2mA
Question: The MOSFET switch in its on-state may be considered equivalent to_____________?
- 1. resistor
- 2. inductor
- 3. capacitor
- 4. battery
Question: An npn BJT has gm=38mA/v, cµ =10¯14 F, cπ =10¯13F and DC current gain β0=90.For this transistor fT & fβ are________?
- 1. fT =1.64 x 108 Hz & fβ = 1.47 x 1010 Hz.
- 2. fT =1.47 x 1010 Hz & fβ = 1.64 x 108 Hz
- 3. fT =1.33 x 1012 Hz & fβ = 1.47 x 1010 Hz
- 4. fT =1.47 x 1010 Hz & fβ = 1.33 x 1012 Hz
Question: An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed____
- 1. 795mV
- 2. 395mV
- 3. 795 mV
- 4. 39.5mV