Question: Class _____________ operation gives the maximum distortion?

• 1. A
• 2. B
• 3. C
• 4. AB

Question: The output stage of a multistage amplifier usually employs _________________?

• 1. Push-pull amplifier
• 2. Preamplifier
• 3. Class A power amplifier
• 4. None of the above

Question: In the design of a biasing circuit, the value of collector load RC is determined by__________________?

• 1. VCE consideration
• 2. VBE consideration
• 3. IB consideration
• 4. None of the above

Question: For germanium transistor amplifier, VCE should_______________for faithful amplification?

• 1. Be zero
• 2. Be 0.2 V
• 3. Not fall below 0.7 V
• 4. None of the above

Question: In a transistor amplifier circuit VCE = VCB +________________?

• 1. VBE
• 2. 2VBE
• 3. 5 VBE
• 4. None of the above

Question: The stability factor of a collector feedback bias circuit is_______________ that of base resistor bias?

• 1. The same as
• 2. More than
• 3. Less than
• 4. None of the above

Question: If the temperature increases, the value of VCE_________________?

• 1. Remains the same
• 2. Is increased
• 3. Is decreased
• 4. None of the above

Question: The value of stability factor for a base resistor bias is________________?

• 1. RB (ß+1)
• 2. (ß+1)RC
• 3. (ß+1)
• 4. 1-ß

Question: In voltage divider bias, VCC = 25 V; R1 = 10 kO; R2 = 2.2 V ; RC = 3.6 V and RE =1 kO. What is the emitter voltage?

• 1. 7 V
• 2. 3 V
• 3. V
• 4. 8 V

Question: In voltage divider bias, operating point is 3 V, 2 mA. If VCC = 9 V, RC = 2.2 kO, what is the value of RE ?

• 1. 2000 O
• 2. 1400 O
• 3. 800 O
• 4. 1600 O