Question: If the maximum collector current due to signal alone is 3 mA, then zero signal collector current should be at least equal to___________________?

• 1. 6 mA
• 2. mA
• 3. 3 mA
• 4. 1 mA

Question: The circuit that provides the best stabilization of operating point is___________________?

• 1. Base resistor bias
• 2. Collector feedback bias
• 3. Potential divider bias
• 4. None of the above

Question: Transistor biasing is generally provided by a_______________?

• 1. Biasing circuit
• 2. Bias battery
• 3. Diode
• 4. None of the above

Question: Transistor biasing is done to keep _____________in the circuit?

• 1. Proper direct current
• 2. Proper alternating current
• 3. The base current small
• 4. Collector current small

Question: For faithful amplification by a transistor circuit, the value of VBE should_____________for a silicon transistor?

• 1. Be zero
• 2. Be 0.01 V
• 3. Not fall below 0.7 V
• 4. Be between 0 V and 0.1 V

Question: The zero signal IC is generally ______________ mA in the initial stages of a transistor amplifier?

• 1. 4
• 2. 1
• 3. 3
• 4. More than 10

Question: The point of intersection of d.c. and a.c. load lines represents __________________?

• 1. Operating point
• 2. Current gain
• 3. Voltage gain
• 4. None of the above

Question: For faithful amplification by a transistor circuit, the value of VCE should______________for silicon transistor?

• 1. Not fall below 1 V
• 2. Be zero
• 3. Be 0.2 V
• 4. None of the above

Question: Operating point represents__________________?

• 1. Values of IC and VCE when signal is applied
• 2. The magnitude of signal
• 3. Zero signal values of IC and VCE
• 4. None of the above

Question: Transistor biasing represents ______________ conditions?

• 1. a.c
• 2. d.c
• 3. both a.c. and d.c
• 4. none of the above